Last week we featured our newest product FastCast™, which is a two-component clear urethane casting resin, which turns white once set. FastCast™ sets to a hard cast in approximately 10 minutes at 70°F. You can check out that post by clicking here.
Today I am going to show how to create a mold for knobs using Silicone Putty. Be sure to check back on Thursday, as I will show you how to make some knobs using these molds and FastCast™.
Here is how to create a mold:
Start with Silicone Putty
Measure out two equal balls of part A and B
Mix them together
Until you have a uniform color.
Push desired knob into the prepared Silicone Putty...
Let set for 20 minutes.
Remove the knob from the Silicone Putty. That is how easy it is to create a mold that you will be able to use over and over again.
That looks pretty quick and easy! Very neat product.
ReplyDeleteThat looks pretty quick and easy! Very neat product.
ReplyDelete