Thursday, December 1, 2016

FastCast™ Holiday Place Card Holders


Hi All, Donna here, I am going to show you how to make some beautiful Holiday Place Card Holders!  These are so easy and FAST!



Materials:
Mixing Cups
Stir Sticks
Snowflake Mold
Glitter Glass or Glitter - Optional
Glue
18 Gauge Wire

Additional Items:
Drill & Bit
Needle nose Pliers

Instructions:

Measure equal parts of Fast Cast™ into a mixing cup.

Mix thoroughly for 30 seconds, pour into a 2nd mixing cup and stir for another 30 seconds.    Then, pour into mold very quickly.  Wait approximately 10-15 minutes and remove from mold


 They are beautiful straight out of the mold. 

Look at the detail!

Using a small drill bit to fit the wire. Drill a hole in the center of the snowflake.

Using the needle nose pliers cut the wire to length desired and curl one end.
Adhere into the hole using glue. Once dry, water down some white glue and lightly brush on snowflake and wire. Dip into or pour glitter glass over it. Let dry.

While drying you could make your place cards.  I cut a 2" X 3" piece of cardstock from DCWV.



Here are a few of the ways you could use these for the holidays!


Thanks for joining me and I hope you enjoyed today's project!

I would love for you to try this fun and easy project for the holidays!


2 comments:

Thank you so much for leaving a comment on Resin Crafts Blog! For technical questions you can email our customer service at: msanchez@eti-usa.com or via telephone @ 1-800-368-9323.