Thursday, April 28, 2016

Resin Floral Bracelet

 I am always on the lookout for new molds to use with ETI products.  Last week I found one that had a several flowers that could be used for so many things.  Today, I am sharing a resin floral bracelet.

Materials List:
  • EnviroTex® Jewelry Resin 
  • Iridescent Powder
  • Bracelet, pre-made metal
  • Crystals, flat back
  • Craft brush
  • Stir sticks
  • Craft sheet or plastic for your work surface
  • Lighter

    Project Instructions: 

      Measure out equal parts of the resin and hardener, stir for two minutes.

     Pour into a second cup and stir for another minute.

     Stir in a small amount of Iridescent Powder, to color the resin.  (If you want several colors, divide the resin into a few different cups.)

     Use the stir stick to drop the resin into the mold.

     Use a lighter to remove any air bubbles that rise to the top.  Let dry for 12 hours..

     Remove flowers from the mold.

    Mix a small amount of Jewelry Resin, as previously shown above.  Use a stir stick to drop a small amount into the bezels on the bracelet, place a flower onto the bezel.

     Use a craft brush to apply a thin layer of resin onto each flower, placing a crystal in the center of each.  

     Let dry for 12 hours.


    No comments:

    Post a Comment

    Thank you so much for leaving a comment on Resin Crafts Blog! For technical questions you can email our customer service at: or via telephone @ 1-800-368-9323.