Thursday, December 17, 2015

Easy Resin Christmas Ornament

There is still time to grab your decorative papers and stickers and create some Easy Resin Christmas Ornaments to put on your tree or add to a package, instead of a bow, and give as a gift!


This ornament was done with a dimensional glittered sticker, EasyCast®, ultra fine glitter, Mold Release and a small circle mold.

Here how to create this ornament:

Measure out equal amounts of the EasyCast® hardener and resin.

Mix them together.

Stir for two minutes. 
 Then pour back into the first cup and stir for another minute.

I added some ultra fine glitter.

Spray the mold with mold release and pour resin into the mold, about 1/8" - 1/4".

Use a lighter to remove any air bubbles that rise to the top and set aside for 12 hours,

Mix another small batch of EasyCast® and pour into the mold.

Place the sticker into the mold.

Move it around until you are happy with the placement.
It should be covered with the resin.
Use a lighter to remove any air bubbles that rise to the top and let set for 24 hours.

Pop out of the mold and add a ribbon around the edge along with a gold twine to create a hanger and place on your tree...it is that easy!

1 comment:

Thank you so much for leaving a comment on Resin Crafts Blog! For technical questions you can email our customer service at: msanchez@eti-usa.com or via telephone @ 1-800-368-9323.