I came across this circular sign recently and knew it would fit perfectly in my craft room.
The letter is recessed so it made for a great base onto which to add assorted elements and then seal with EasyCast.
I combined equal parts resin and hardener then, per the directions, I mixed it for 2 minutes.
Next, I poured the mix into a clean cup and mixed it again for another minute.
I poured a light layer of epoxy over the sign, then added an assortment of embellishments.
Once all the elements were added, I poured on additional epoxy to seal them in place.
Then I placed my piece aside to allow it time to dry.
I was very surprised and happy to see that the hardening process began in less than 30 minutes.
Thanks for stopping by today.